Operating Instructions

17
TQBJ2186
17
“USB NO DEVICE”
• The USB device is not connected. Examine the connection.
“USB OVER CURRENT ERROR”
• The USB device is drawing too much power. Disconnect the
USB device, switch off the system and then switch on again.
• Check the connection, it may be caused by a faulty USB
cable.
“VBR”
• The system cannot show the remaining play time for variable
bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [SELECT] repeatedly on the unit to select “AUX”.
█ To set the code to “REMOTE 2”
1 Press and hold [SELECT] on the unit and [<] until
“REMOTE 2” is shown.
2 Press and hold [OK] and [<] for a minimum of
4 seconds.
█ To set the code to “REMOTE 1”
1 Press and hold [SELECT] on the unit and [ ] on
the remote control until “REMOTE 1” is shown.
2 Press and hold [OK] and [ ] on the remote
control for a minimum of 4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 Press and hold [1] on the unit until “RESET?” is
shown.
2 While you press and hold [1] on the unit, press
[SELECT].
“RESET” is shown.
After “–––––––––” is shown, the unit will switch
off automatically.
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
DEMO play
The unit will play built-in demonstration song for 1 minute.
1 Press and hold for more than 2 seconds.
“WAIT FOR DEMO PLAY” is shown while you press
and hold the button.
Demonstration song is played and “DEMOPLAY” is
shown.
2 Press [8] to stop the demonstration song.
ENGLISH
SC-TMAX10E_TQBJ2186 (01) En.fm Page 17 Wednesday, June 1, 2022 1:26 PM