Operating Instructions

82
VQT3E82
≥ The disc that was copied to can be played back by connecting this unit and a DVD
burner. (l 83)
≥ Do not turn off this unit or the DVD burner or disconnect the USB Connection Cable while
copying. Also, do not shake this unit or the DVD burner.
≥ It is impossible to stop copying halfway.
≥ The order in which the scenes were copied cannot be changed.
≥ Data that has been recorded on another device may not be copied.
≥ Because copying is carried out in units of scenes, unused disc space may arise when
copying to two or more discs.
≥ There is no guarantee that a disc created by connecting this unit and the DVD burner will
play back on any playable device.
Important Notice
≥ When inserting a disc containing recorded motion/still pictures into other
devices, a message prompting you to format the disc may be displayed. Do not
format the disc, since deleted data cannot be restored later.
Approximate time for copying to a disc
To copy motion pictures to the full capacity of a disc
Disc type Copy time
DVD-RAM Approx. 40 min to 1 h 30 min
DVD-RW
*
/+RW
*
Approx. 30 min to 1 h
DVD-R
*
/+R
*
Approx. 15 min to 1 h
* Even if the data capacity to be copied is small, the time it takes for copying may be
about the same as the time shown in the table.
To copy approx. 600 MB still pictures
Disc type Copy time
DVD-RAM/DVD-RW/DVD-R/
+RW/+R
Approx. 30 min to 40 min
≥ Copy time of DVD-R DL/+R DL is approximately 2 to 3 times that of DVD-R/+R.
≥ Depending on the following conditions, the time it takes for copying may be longer than
the above times.
jWhen the number of recorded scenes is large
jWhen the temperature of the DVD burner has become high
SDRS70&T70&H100EB-VQT3E82_mst.book 82 ページ ２０１０年１２月１日 水曜日 午後２時５２分