Instruction Manual (PP)

29
VQT0T50
Changing the date and time display style
Press the menu button, select
[SETUP]#[ DATE/TIME], then use
the cursor button to select the desired
display style. (P26)
≥ The date and time display can also be
changed by pressing the [DATE/TIME] button
on the remote control.
∫ About date/time
≥ The date and time function are driven by a built-in lithium battery.
≥
Make sure to check the time before recording because the built-in clock is not very accurate.
≥ If [0] or [––] is indicated when this unit is turned on, then the built-in lithium battery
runs down. After charging the battery using the steps below, set the clock.
∫ Charging the built-in battery for the date
≥ Connect the AC adaptor to this unit or place the battery on this unit, and the built-in
lithium battery will be recharged. Leave this unit as is for approx. 24 hours, and the
battery will save the date and time for approx. 6 months. (Even if the [ON/OFF]
switch is set to [OFF], the battery is still being recharged.)
Adjusting the brightness and color level of the LCD monitor
1 Press the menu button, then use the
cursor button to set
[SETUP]#[ LCD SET]#[YES].
(P26)
2 Press the cursor button up or down to
select the item to be adjusted. Then,
press the cursor button left or right to
make the adjustment.
The bar display moves.
– : Brightness of the LCD monitor
– : Color level of the LCD monitor
MENU
SETUP ENTER
EXIT
DISPLAY
FORMAT CARD
DATE/TIME
QUICK START
SETUP
OFF
D/T
DATE
1/3
DATE FORMAT
Adjusting LCD monitor
[OFF]
[D/T]
3:42 PM
DEC 15 2005
[DATE]
DEC 15 2005
MENU
SETUP ENTER
EXIT
POWER SAVE
LCD SET
BEEP SOUND
INITIAL SET
SETUP
YES
NO
2/3
LCD AI
LCD SET
MENU
SETUP ENTER
SET
EXIT
≥ These settings will not affect the images actually recorded.
VQT0T50_PP_ENG.book 29 ページ ２００５年８月３１日 水曜日 午後２時２５分