Operating instructions

5
Before Use
Caution
Do not remove the bread pan or unplug the Bread Maker
during use.
(It may cause a burn or injury.)
Do not use the appliance on following places.
●
Position the Bread Maker on a firm, dry, clean, flat heatproof
worktop at least 10 cm (4 inches) from the edge of the worktop.
(It may cause the appliance to slip and fall from the worktop.)
●
Do not place on unstable surfaces, on electrical appliances
such as a refrigerator, on materials such as tablecloths or on
carpet, etc. (It may cause falling or a fire.)
●
During baking the unit heats up. The Bread Maker should be
placed at least 5 cm (2 inches) from adjacent walls and other objects.
(It may cause a discoloration or deformation.)
Do not touch hot area such as bread pan, inside of unit,
heating element or inside of the lid while the appliance is in
use or after cooking. The temperature of accessible surfaces
may be high when the appliance is operating.
(The surfaces get hot during use which cause burns.)
 To avoid burns, always use oven gloves when removing the bread pan or the
finished bread. (Do not use wet oven gloves.)
Also take care when removing the finished bread or kneading blade.
Important Information
 Do not use the appliance outdoors, in the immediate vicinity of heat sources
or in rooms of high humidity.
(It may cause a malfunction or deformation.)
 Do not use excessive force on the parts as is illustrated on the right.
(It may cause a malfunction or deformation.)
 This appliance is not intended to be operated by means of an external timer or separate remote-control system.
Temperature sensor
Heating element
Inside of the lid
Electrical Requirement
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13-amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13-amp and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark
or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover, the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the fitted moulded plug is unsuitable for the socket outlet in your home, then the fuse should be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted
into any 13-amp socket.
How to replace the fuse
The location of the fuse differs according to the type of AC mains plug (figures
A and B). Confirm the AC mains plug fitted and follow the instructions below.
Illustrations may differ from actual AC mains plug.
Open the fuse cover with a screwdriver and replace the fuse and close or attach
the fuse cover.
Figure A Figure B
Fuse cover
SD-ZB2512_UK.indd 5 2015/01/09 15:29:54