Technics Stereo Graphic Equalizer SH-8038 OPERATING Before operating INSTRUCTIONS this unit, please read these instructions completely.
Technics, The Science of Sound, welcomes the challenge of new audio technologies and brings you a multitude of world-renowned, high quality audio components, all backed by our time-honored commitment to innovation, value, and quality.
Suggestions for Safety 11. Before using this unit, be sure to read applicable items of the operating instructions and these safety suggestions carefully. Afterwards keep them handy for future reference. Take special care to follow the warnings indicated on the unit itself as well as in the operating instructions. • Water and Moisture -- The unit should not be used near water -- for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like.
Connections • Refer to the operating instructions amplifier for further details. Connect to the input/output (EXT OUT/EXT IN) terminals of an integrated Using the connection diagram below, corrected signals from any source External output terminals (EXT OUT) External input terminals amplifier. can be heard or recorded of the / J onto the tape deck. I (EXT IN) I Integrated amplifier (option) )(R)(L)(R)(L) If the amplifier does not have external input/output terminals (EXT OUT/EXT IN).
Front Panel Controls and Functions Power switch (power) This switch turns on and off the secondary circuit power only. The unit is in the "standby" condition when this switch is set to the "off" (.= _ II) position. Regardless of the switch setting, the primary circuit is always "live" as long as the power cord is connected to an electrical outlet. Left channel Band-level controls (left) These levers are used to adjust the 7 frequency levels.
Note: Operation Turn the amplifier on, and set it for listening to the sound. (Refer to the operating instructions of the amplifier.) Reduce the volume level of the amplifier. Set super the amplifier's tone controls the"OFF". center position, and set _ the bass or loudness switchto to Set the tape-monitor "Tape" position. (Referselector to note) of the amplifier to Set the power switch to "on". (Refer to the operating instructions of the amplifier for further details.
Examples of Applications By using the seven frequency divisions and tone quality are possible. in the 63 Hz-16 kHz frequency range of the equalization function, various corrections of the sound field f For creation of a sound field in the listening For editing "live" etc. room. • Correcting room acoustics • Cutting the noise from live recording tapes Live tapes recorded outdoors generally contain popping noises caused by wind and various other noises from the surrounding area.
Troubleshooting Guide Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.
