Operating Instructions

Anti-skating control
Arm clamp
Arm rest
Cue lever
1
Free the tone arm from the arm
rest and adjust horizontal balance
by turning the balance weight.
Hold the tone arm and turn the balance
weight in the arrow direction to adjust
the balance until the arm is approximately
horizontal.

Take care not to
allow the stylus tip
to touch the
turntable or main
unit.
Balance weight
Hold here
to turn
18
1
Turn the stylus pressure control
until “0“ comes to the centre line
of the rear of the
tone arm.

Hold the balance
weight still while
doing this.
2
Turn the balance weight to adjust
to the appropriate stylus pressure
for the cartridge.

The stylus pressure control will turn
together with the
balance weight.

Turn until the centre
line points to the
appropriate stylus
pressure.
Preparation

First, remove the dust cover.

Return the tone arm to the arm rest and fix it
with the arm clamp.
Horizontal balance Stylus pressure
Preparation

First, remove the dust cover.

Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.

Lower the cue lever.

Turn the anti-skating control to “0”.
Adjustment
Centre line
Balance weight
Arm clamp
Centre line
Stylus pressure
control
Hold here
to turn
Balance weight
Hold here
to turn
Turns
together
Balanced and the tone
arm is parallel to the
turntable.
The balance weight is
too far forward.
The balance weight is
too far back.

Refer to the user’s guide for your stylus for
the appropriate stylus pressure.
Note
0
1
3
2
Anti-skating
1
Turn the anti-skating control to
adjust it to the same value as the
stylus pressure control.

For stylus pressures 3
g
and above, adjust anti-skating control to “3”.
Note
SL-1200GR2EBTQBM0908.indd19SL-1200GR2EBTQBM0908.indd19 2023/06/3015:10:582023/06/3015:10:58