Operating Instructions

14
This unit is designed to conserve its power consumption and
save energy. The unit will turn to standby mode automatically
if there is no sound and it is not being used for approximately
20 minutes.
≥ The factory default is “On”.
To cancel this function
1 Press and hold [MUTE] until the PHONO
indicator on this unit starts to blink.
2 Press [MUTE].
Each time you press the button:
3 Press [VOL s] to exit.

≥ You will exit the auto off setup mode if you do not operate any
buttons and controls for approximately 10 seconds after any of the
three indicators above starts blinking.
When other equipment responds to the supplied remote
control, change the remote control code.
≥ The factory default is “1”.
Point the remote control at this unit, and
press and hold [OK] and the numeric button
for at least 4 seconds.
≥When the code is changed, the PC indicator and the
COAX2 indicator blink for approximately 10 seconds.

≥ When the ST-C700/SL-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
You can automatically link this unit with the ST-C700/SL-
C700 and operate them easily with the remote control.
Preparation
1 Connect this unit and the ST-C700/SL-C700 with system
connection cables and coaxial digital cables. (> 10)
2 Set the power switch lever of this unit and the ST-
C700/SL-C700 to the [Í/I] position.
∫ Switching this unit and the ST-C700/SL-
C700 to on/standby simultaneously
≥If you point the remote control at this unit and press
[AMP Í] when this unit and the ST-C700/SL-C700 are in
standby mode, this unit and the device of the selected input
source will be turned on simultaneously.
≥If you point the remote control at this unit and press
[AMP Í] when this unit and the ST-C700/SL-C700 are
turned on, this unit and the ST-C700/SL-C700 will
simultaneously enter standby mode.
∫ Switching this unit’s input source
automatically
When you perform an operation such as playback on the ST-
C700/SL-C700, the input source of this unit will be
automatically switched to “COAX1”/“COAX2”.

≥ For information on the operations of the ST-C700/SL-C700, please
also refer to their operating instructions.
≥ If you install the dedicated app “Technics Music App” (free of
charge) on your tablet/smartphone, you can use a wide variety of
functions when the unit and the ST-C700 are connected.
For details, visit:
www.technics.com/support/
Auto off function
COAX3 indicator blinks On
OPT indicator blinks Off
Remote control code
[OK] + [1] Set the code to 1
[OK] + [2] Set the code to 2
Using the system control
function
SU-C700-SQT0487_EBGN_mst.book 14 ページ ２０１５年６月１５日 月曜日 午前９時２０分