Operating Instructions

15
Basic
Wired LAN connection
Broadband router, etc.
LAN cable
(not supplied)
1 Disconnect the AC mains lead.
2 Connect this unit to a broadband
router, etc. using a LAN cable.
3 Connect the AC mains lead to this
unit. ( 13)
4 Press [
] to turn this unit on.
• When the connection is established,
“
” is displayed.
5 Press [>INPUT<] to select
“Chromecast built-in™”.
(Using Google Home app)
6 Open the Google Home app and
follow the on-screen instructions to
set up a connection. ( 17)
(Using Apple Home app)
6 Open Apple Home app and follow
the on-screen instructions to set up a
connection. ( 17)
Note
• While the AC mains lead is disconnected, the
LAN cable must be connected or disconnected.
• Use category 7 or above straight LAN cables
(STP) when connecting to peripheral devices.
• Inserting any cable other than a LAN cable in
the LAN port can damage the unit.
• When a LAN cable is connected, the Wi-Fi
function may be disabled.
Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable.
Place this unit as close to the wireless router
as possible.
Point up the antenna on the rear of this unit
as shown in the figure.
Connect the AC mains lead to this unit. ( 13)
Note
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
]
or turn the unit to standby mode.
• When the connection is established, “
” is
displayed. ( 17)
Network setting for the first time
using app
1 Press [ ] to turn this unit on.
• “Wi-Fi Setup” is displayed.
2 Press [ ], [ ] to select “Yes” and
then press [OK].
• “Setting” is displayed.
(Using Google Home app)
3 Open the Google Home app and
follow the on-screen instructions to
set up a connection. ( 17)
(Using Apple Home app)
3 Open Apple Home app and follow
the on-screen instructions to set up a
connection. ( 17)
Note
• This unit will be displayed as “Technics-SU-
GX70-
****
” if the device name is not set.
(“
****
” stands for characters unique to each
set.)
• You can check your network information (SSID,
MAC address and IP address) from the Google
Home app or “Technics Audio Center” app.
• Some items on the Google Home app are
irrelevant to this unit.
• When this unit is switched to standby mode
and turned on before the Wi-Fi setting is
complete, “Wi-Fi Setup” is displayed. Complete
the Wi-Fi setting or set “Wi-Fi Menu” to “Off”
to turn off the display.