Operating instructions

Part VIII Sound Edit
115
QQTG0701
Sound Edit
FILTER ENVELOPE
Specify how the filter changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons view the 3/4 display.
• The display looks similar to the following.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
3.
Use the
∧
and
∨
buttons to modify the respec-
tive filter envelopes.
• Use the buttons below the display to adjust the respective
settings.
• You can select CUTOFF ADJUST and use the
∧
and
∨
buttons to set the total upper and lower settings, the
START POINT to set the start point, and the STOP
POINT to set the stop point.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
FILTER ENVELOPE TOUCH & KEY
FOLLOW
Specify how the filter envelope (curve) changes
relative to touch or note pitch.
1.
Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
3.
Modify how the respective filter envelopes
change relative to touch.
• Select TOUCH TIME and use the
∧
and
∨
buttons to
specify the time change, and select TOUCH LEVEL and
use the
∧
and
∨
buttons to specify the level, relative to
touch.
• At a − setting, the softer the keys are played, the greater
the change. At a + setting, the harder the keys are
played, the greater the change.
4.
Select KEY FOLLOW and use the
∧ and ∨
buttons to modify how the respective filter
envelopes change relative to note pitch.
• Adjust the respective slopes for attack, decay and
release. Select CENTER and use the
∧
and
∨
buttons to
specify the center of the bend slope by note name.
13_Part VIII.fm 115 ページ ２００３年５月２０日 火曜日 午前８時２１分