User Manual BLE TAG 0/6
1. Product Introduction TFX701C is IoT electronic equipment tracker supports the transmission and rec eption of BLE (Bluetooth Low Energy) 4.0 wireless communication protocol. This tr acker is simple and sensitive, easy to deploy and can be used for indoor coverage in smart office and factory application. Its effective transmission distance from BLE Anchor is 10 meters.
2. Hardware Specifications Item Technical Information Processor ARM® Cortex®-M0 Storage/Memory 384 KB/ 192 KB RF Connectivity BT 4.
3. Installation guide There are two ways to install tag on the device 3.1 Use ribbon to tie the BLE TAG to the device. Figure 2 3.2 Use welding glue ERGO.
4.Software setup System website: http://10.116.24.152/FIIpmsys Open the IOT positioning system, select Staff/Equipment Management to add Tag，input Mac and corresponding information .As shown in the figure 4. Click Edit to modify the device label information. As shown in the figure 5、6、7 below, Modify tag binding personnel.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
