Operation Manual

7
Accessories Supply
Accessories
Power supply cord
Check that you have the accessories and items shown
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Remote Control
Transmitter
N2QAYB000562
Batteries for
the Remote
Control
Transmitter
(R6 (UM3) Size × 2)
Fixing band × 2
TMME203
These accessories will be used by professional installers when
they install the unit.
TH-85VX200W
TH-103VX200W
Eyebolt cap × 1
Eyebolt cap × 1 Allen wrench
Eyebolt × 1
(M12)
Allen wrench
Clamper × 1
TMM15412-2
TH-85VX200W
Ferrite core × 2
J0KG00000014
Noise cut fi lter
TXZDM011MBE
Use the clamper
when connecting a
LAN cable.
(see page 55)
Use the Ferrite cores and Noise cut fi lter to comply
with the EMC standard. (see page 55)
Remote Control Batteries
Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
2. Insert batteries - note correct
polarity ( + and -).
Helpful Hint:
For frequent remote control
users, replace old batteries
with Alkaline batteries for
longer life.
Open
Close
Hook
“R6 (UM3)” size
3D Eyewear set
(see page 20)
Screwdriver
Operating Instructions
For 3D Eyewear
(see page 21)
Eyebolt × 1
(M16)