Operation Manual

8
1
2
SERIALPC IN
AUDIO
SLOT1 SLOT2 SLOT3
1
2
Connections
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
AC cord connection (see page 11)
– AC cord fi xing
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
Optional Terminal
Board Insert Slot
(covered)
Note:
Make sure that the AC cord is locked
on both the left and right sides.
Push until
the hook
clicks.
2. Pull off.
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Close
Open
1
Plug the AC cord into
the display unit.
Plug the AC cord until
it clicks.
2
Fix the AC cord with
the clamper. which
is atttached to the
unit.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
1. Keep the
knob pressed.