Operating Instructions

L
R
PC IN
AUDIO IN
Y
P
B
PR
L
R
L
R
VIDEO
AUDIOAUDIO
AV
RGB
VIDEO
S VIDEO
RGB
VIDEO
S VIDEO
VIDEO
COMPONENT
AV1 AV2 AV4
AUDIO
IN
PC
41
Connections
How to connect the PC Input terminal
Notes:
• Connect a cable which matches the audio output terminal on the computer.
• Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and vertical
scanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024
lines.)
• The display resolution is a maximum of 768 × 720 dots (TH-37PV500E), 768 × 768 dots (TH-42PV500E), 1,024
× 768 dots (TH-50PV500E) when the aspect mode is set to “4:3”, and 1,024 × 720 dots (TH-37PV500E), 1,024 ×
768 dots (TH-42PV500E), 1,366 × 768 dots (TH-50PV500E) when the aspect mode is set to “16:9”. If the display
resolution exceeds these maximums, it may not be possible to show fi ne detail with suffi cient clarity.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• For applicable PC signals information see page 44.
Signal Names for D-sub 15P Connector
1
678
3
9
45
10
15 14 13 12 11
2
Pin Layout for PC Input
Terminal
Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name
1
R
6
GND (Ground)
11
NC (not connected)
2
G
7
GND (Ground)
12
NC (not connected)
3
B
8
GND (Ground)
13
HD/SYNC
4
NC (not connected)
9
NC (not connected)
14
VD
5
GND (Ground)
10
GND (Ground)
15
NC (not connected)
COMPUTER
RGB
AUDIO
(D-sub 15p)
(Stereo plug)
Conversion adapter (if necessary)
Less than
10 cm
Ferrite core (Large size)