Operating Instructions

Advanced
Menu
Item Adjustments / Confi gurations (options)
Picture
Advanced
PC
Settings
W/B High R White balance of bright red area
and
repeatedly adjusted
W/B High B White balance of bright blue area
W/B Low R White balance of bright red area
W/B Low B White balance of dark blue area
Gamma (2.0 / 2.2 / 2.5 / S Curve)
Setup
PC
Setup
Input
Resolution
Switches to a wide view
•
VGA (640 × 480 pixels), WVGA (852 × 480 pixels),
XGA (1,024 × 768 pixels), WXGA (1,366 × 768 pixels)
•
Options change depending on signals
Clock Set to the minimum level if noise occurs
H-pos
Adjusts horizontal position
V-pos
Adjusts vertical position
Clock Phase
Eliminates fl icker and distortion
•
Adjust after Clock adjustment
•
Set to the minimum level if noise occurs
Sync
Chooses another synchronous signal if the image is distorted (H & V / On G)
•
H & V : by the horizontal and vertical signals from your PC
On G : by the green signal from your PC (if available)
OPTION DIRECT TV REC
EXIT
RETURN
INPUT
Input Selection
AV1
AV2/AV2S
COMPONENT
PC
HDMI1
HDMI2
TV
Main Menu
VIERA Link
Picture
Sound
Setup
2/2
System Information
Software License
VIERA Link
Refresh Rate 100Hz
On
Setup Menu
Input Labels Access
Banner Display Timeout 3 seconds
OPTION DIRECT TV REC
RETURN
INPUT
EXIT
TV
Input Labels
AV1 DVD
AV2/AV2S AV2/AV2S
COMPONENT COMPONENT
PC PC
HDMI1 HDMI1
HDMI2 HDMI2
26
27
•
Displaying PC Screen on TV
•
Input Labels
■
To return to TV
Displaying PC Screen on TV
Select the external input
Select “PC”
2
The screen of the PC connected to the TV can be displayed on the TV.
You can also listen to PC sound with the audio cable connected. To connect PC
(p. 32)
•
Corresponding signals (p. 36)
•
If “H-freq.” or “V-freq.” is shown in red,
the signals may not be supported.
■
PC menu setting (changed as desired)
•
To make settings “How to Use Menu Functions” to (p. 18)
•
Other items p. 20 and p. 21
1
Input Labels
2
3
4
Select “Setup”
Select “Input Labels”
Display the menu
Select a input terminal and set
■
To return to TV
EXIT
For easier identifi cation and selection of the input mode, you can label each input terminals or skip
terminal that is not connected to any equipment.
(To select the input mode
p. 14)
1
The labels you set will be displayed in “Input Selection” menu (p. 14) or banner.
•
If “Skip” is selected, you cannot select the mode.
User Input
Name
ABCDEFGH I JKLMN
UVWXYZ 0123456
abcdef ghi j k lmn
uvwxyz( )+- . *_
OPQRST
789! : #
opqr s t
■
User Input
You can name each input terminals freely.
Select “User Input” Set characters
(maximum: ten characters)
set
select
access
select
access
select
access
select
store
select
access
select