Operating Instructions

30
Tuning Channels
Off
DVB Signal Condition
DVB Programme [70] CBBC Channel
0 5 10
Signal Quality
Signal Strength
Selects a channel and checks the DVB signal condition.
Use for adjusting the direction of the aerial.
Signal Quality:
•
Green bar Good
•
Yellow bar Poor
•
Red bar Bad (Check the aerial)
•
To change the programme during the menu appears
Check
DVB signal
DVB Signal
Condition
Display a
notifi cation
message
New Service
Message
New DVB service found!
Press OK to add new service.
Press EXIT to lgnore.
Selects whether to give a notifi cation message when a new DVB service is found. (Off / On)
Set DVB
channel
manually
Normally use “Auto Setup” or “Add New DVB Services” for the DVB channel setting.
If tuning has not done completely, use this function.
DVB Manual Tuning
Signal Quality
Stopped
0 10
Signal Strength 0 10
Frequency MHz
[
CH21
]
474,00
Prog. Channel Net ID. Quality
TS ID.Service Name
•
All services found will be added to the
DVB Service List (p. 27) automatically.
DVB Manual
Tuning
Add
DVB channel
automatically
Any new services found will be added to the DVB Service List (p. 27) automatically.
Add New DVB Services
Please wait!
This will take about 3 mins.
569
Prog. Channel Service Name Net ID. TS ID. Quality
ZDF
ARD
•
The new service is added with the current settings
saved as they are.
Add New
DVB Services
Set Analogue
channel
manually
Fine Tuning
Programme 1 [CH33]
Analogue Manual Tuning
Manual Tuning 2 78 411
■
Fine Tuning
Use to make small adjustments to the tuning of an individual channel (affected by weather
conditions, etc.)
■
Manual Tuning
Set Analogue channel manually after Auto Setup.
If a VCR is connected with only the RF cable, select programme position “0”.
Search and storeSelect the channelSelect the programme position
Analogue
Manual Tuning
adjust frequency
( set where the level of “Signal Quality”
becomes the maximum)
select channel
search
store
search