Operating Instructions

Remote Control Batteries

Requires two R6 batteries.

1. Pull and hold the hook, then open

the battery cover.

2. Insert batteries - note correct

polarity (+ and -).

3. Replace the cover.

Helpful Hint:

For frequent remote control users, replace old batteries with Alkaline

batteries for longer life.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Disposal of batteries should be in an environment-friendly manner.

Observe the following precaution:

1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.

2. Do not combine a used battery with a new one.

3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

Battery replacement is necessary when remote control acts sporadically or stops operating the Display set.

6. Do not burn or breakup batteries.

7. Batteries must not be exposed to excessive heat such as sunshine, ﬁ re or the like.

“R6 (UM3)” size

Contents in the CD-ROM

The contents below are included in the supplied CD-ROM.

Instruction

(PDF)

Operating Instructions - Display Operations

Operating Instructions - Network Operations

Operating Instructions - Wireless Manager ME

Software license GNU GENERAL PUBLIC LICENSE

GNU LESSER GENERAL PUBLIC LICENSE

Software

WhiteBoard Software (Windows) Allows the display to be used as whiteboard.

You can run the software directly from external

storage without installing it in your computer.

(see page 44)

Wireless Manager ME (Windows/Mac) Allows the image on the computer screen to be

sent wirelessly or via wired LAN.

Switch the input to Panasonic APPLICATION

before use. For more details, see the instruction

manual of Wireless Manager ME.

Accessories