Operating Instructions
69
Setup for Input Signals
Signal menu
Notes:
• “Signal” setup menu displays a different setting condition for each input signal.
• Depending on the input signal type, an optional Terminal Board may be required.
• 3D Y/C Filter (NTSC)
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Set this menu when the moving image looks unnatural during Video (S Video) input signal.
On Off
Note:
When On, this setting only affects NTSC input signals.
• Colour system
Auto SECAM M.NTSC NTSCPAL
Set the colour system to match the input signal. When “Auto” is set, Colour system will be automatically selected
from NTSC/PAL/SECAM/M.NTSC.
To display PAL60 signal, select “Auto” or “PAL”.
If the picture image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases
become unstable. Should this occur, set the system to match the format of the input signal.
• Cinema reality
When “On”, the display attempts to reproduce a more natural interpretation of sources such as movie pictures,
which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to “Off”.
On Off
Note:
When On, this setting only affects the following signal input:
• NTSC / PAL signal input during Video (S Video) input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during “Component” input signal.
• XGA Mode
This menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA
signals with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz,
1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
Auto 1024×768 1280×768 1366×768
Auto: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view or display
resolution condition.
Note:
After making this setting, be sure to make each adjustment (such as “Auto Setup”) on the “Pos./Size” menu as
necessary. (see page 48)
Select “Signal” in “Setup” menu and press button.
Signal [Digital]
Cinema reality
HDMI Range
Auto
Off
Off
Noise reduction
63.98
kHz
60.02 Hz
H-Freq.
V-Freq.
1280×1024/60iSignal Format
For Video (S VIDEO) For RGB
For Component
For Digital
Signal
[
AV
]
3D Y/C Filter (NTSC)
Colour system
Auto
On
Off
Off
Cinema reality
Noise reduction
Signal
[ RGB ]
63.98 kHz
60.02 Hz
1280×1024/60i
H-Freq.
V-Freq.
Signal Format
Sync
Cinema reality
Off
Auto
Auto
Off
XGA Mode
Noise reduction
Signal [
Component
]
63.98 kHz
60.02 Hz
1280×1024/60i
H-Freq.
V-Freq.
Signal Format
Sync
Cinema reality
Off
Auto
Auto
Off
XGA Mode
Noise reduction