Operating Instructions

7
Safety Precautions
Touch panel
Carefully observe the following instructions as the display has an optical touch panel.
Do not expose the display to direct sunlight or strong light source during use.
• Otherwise malfunction may occur since the optical touch panel of the display uses infrared rays.
After turning on the power of the display, do not touch the IR transmission part
and the screen until any image is displayed.
• Otherwise the touched part may be detected as defective elements, resulting in
abnormal operation. If this occurred, turn the display off and then on.
Always use a fi nger or the supplied pen to operate the touch panel. Do not use a hard or sharp tip such as nail, ball-point pen, and pencil.
When using any other infrared device, keep a distance to prevent erroneous operation.
IR transmission part
Clamper × 1
TMME289
Batteries for the Remote
Control Transmitter
(R6 (UM3) Size × 2)
Remote Control
Transmitter
N2QAYB000691
Operating
Instruction book
Check that you have the accessories and items shown
Software CD-ROM × 1
Pen × 2 Eraser × 1 Pen Stand × 1
(see page 9)
Screw × 2
(see page 9)
USB cable × 1 Ferrite core × 2
J0KG00000014
Cable tie × 2
TMM17499
Power supply cord
TH-50LFB70U, TH-65LFB70U TH-50LFB70E, TH-65LFB70E TH-50LFB70W, TH-65LFB70W
Use the Ferrite cores
to comply with the EMC
standard. (see page 13)
Accessories Supply
Accessories
Attention
Store small parts in an appropriate manner, and keep them away from young children.