Operating Instructions

SLOT1
1
2
1
2
1
2
SERIALPC IN
AUDIO
SLOT2 SLOT3
VIDEO
AUDIO
RL
AUDIO
RL
AV INBA
S VIDEO
1
2
8
Note:
Make sure that the AC cord
is locked on both the left and
right sides.
Push until
the hook
clicks.
2. Pull off.
Close
Open
1
Plug the AC cord into
the display unit.
Plug the AC cord until
it clicks.
2
Fix the AC cord with
the clamper which
is atttached to the
unit.
1. Keep the
knob pressed.
Connections
Speaker
terminal (R)
Speaker
terminal (L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-50PH11EK)
AC cord connection (see page 12)
Speakers (Optional accessories)
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten: To loosen:
Pull
Pull
Push the catch
– AC cord fi xing
Note: Terminal board is installed in SLOT 1 at factory shipment.
Dual Video Terminals (equivalent
of BNC Dual Video Terminal Board
(TY-FB9BD)) (see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 9)
From SERIAL Terminal
on Computer
(see page 10)
Optional Terminal
Board Insert Slot
(covered)
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.