Operating Instructions

15
Basic Controls
Standby (ON / OFF) button
The Plasma Display must fi rst be plugged into the wall outlet and turned on at the power switch (see page 12).
Press ON to turn the Plasma Display On, from Standby mode. Press OFF to turn the Plasma Display Off
to Standby mode.
POSITION buttons
SET UP button (see page 16, 17)
DIRECT INPUT buttons
Press the INPUT “1”, “2”, “3” or “PC” input mode selection button to
select the PC input mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed. If you
press the button whose slot is not installed, it automatically displays
the current input signal.
Note:
After-image (image lag) may occur on the plasma display panel when
a still picture is kept on the panel for an extended period. The function
that darkens the screen slightly is activated to prevent after-image (see
page 42), this function is not the perfect solution to after-image.
Channel Adjustment
This button cannot be used for this model.
Volume Adjustment
Press the Volume Up “+” or Down “–” button to increase or decrease
the sound volume level.
OFF TIMER button
The Plasma Display can be preset to switch to stand-by after a fi xed
period. The setting changes to 30 minutes, 60 minutes, 90 minutes
and 0 minutes (off timer cancelled) each time the button is pressed.
When three minutes remain, “OFF TIMER 3” will fl ash.
The off timer is cancelled if a power interruption occurs.
Remote ID lock (see page 34)
Status button
Press the “Status” button to display the current system status.
1
Input label
2
Aspect mode (see page 18)
3
Off timer
The off timer indicator is displayed only when the off timer
has been set.
Digital Zoom (see page 25)
Press to access
Digital Zoom.
This displays an enlargement of the designated part of the
displayed image.
ACTION button
Press to make
selections.
SOUND button
(see page 24)
R button (see page 17)
Press the R button to return to previous menu screen.
Off timer 90
2
3
1
PC
4:3
30 60
0
90