Operating Instructions

17
When experiencing problems, please refer to the table below for possible solutions. If the problem persists,
contact your dealer.
Symptom Possible cause and solution See page
The power indicator
blinks red
No rechargeable battery is in during charging or a battery
incompatible with this electronic pen is charged
→ Use a rechargeable AAA Ni-MH battery.
9, 10
The power indicator
blinks green
The rechargeable AAA Ni-MH battery or alkaline battery is low.
→ Charge the rechargeable AAA Ni-MH battery or replace the
alkaline battery with a new one.
9, 10
The function indicator
blinks red and green
alternately
The electronic pen is not registered to the electronic pen adapter.
→ Register the electronic pen to the electronic pen adapter.
9, 13
Drawing response is
slow
• Check that your computer satisfies the system requirements of
the electronic pen.
• Other applications or anti-virus software are active.
→ Shut down the other applications and anti-virus software.
2
The electronic pen loses
the functions.
(Buttons are
unresponsive.)
(Lines written with the
electronic pen are broken
or colors change.)
• Check that the electronic pen adapter is correctly connected.
• Check that the electronic pen is correctly registered to the
electronic pen adapter.
• Other applications or anti-virus software are active.
→ Shut down the other applications and anti-virus software.
• The rechargeable AAA Ni-MH battery or alkaline battery is low.
→ Charge the rechargeable AAA Ni-MH battery or replace the
alkaline battery with a new one.
• The electronic pen is used with the wireless module (ET-
WM200E) connected.
→ Using the electronic pen with the wireless module (ET-
WM200E) connected may result in malfunction of the
electronic pen due to radio wave interference as an example.
In that case, set “Wireless Lan” to “Off” before using the
electronic pen.
13
13
2
10
See
Network
Operations
of the
operating
instructions
Troubleshooting