Operation Manual

21
English
Manual Tuning
 Analogue Manual Tuning
Set Analogue channel manually after [Automatic
Channel Search].
1 Enter the frequency to start scanning
Analogue Manual Tuning
Searching channels
Start Frequency (MHz) 48.00
Scan up Scan down
2 Select the scanning method
[Scan up]: Scans ascendingly from the entered
frequency to higher frequencies.
[Scan down]: Scans descendingly from the entered
frequency to lower frequencies.
 DVB Manual Tuning
Normally use [Automatic Channel Search] or [Scan] to
retune DVB channels.
If tuning has not been done completely or for adjusting
the direction of the aerial, use this function.

All channels found will be added to the [Channel List].
DVB-C
1 Enter the frequency
DVB-C Manual Tuning
Scan
0%
Cable
Frequency (kHz)
306000
Modulation
Auto
Symbol Rate(ksym/s)
6875
Signal Level
0
Signal Condition
0
2 Start scan
DVB-T
Select channel and start scan
DVB-T Manual Tuning
Scan
0%
Antenna
Channel
2
Signal Level
0
Signal Condition
0
Tuning and Editing
Channels
You can retune channels or make your favourite channel
lists, skip unwanted channels, etc.
[Setup] [Tuning Menu]
*
*
The menu name varies depending on the TV mode.

The settings in [Tuning Menu] are applicable only for
the selected TV mode.
Retuning channels

Only the selected mode is retuned. All the previous
tuning settings are erased.
1 Set [TV Selection] to the signal you want to tune
TV Selection Antenna
2 Select [Automatic Channel Search]
Automatic Channel Search Access
3 Select the provider (Cable only)
4 Set the settings for [Automatic Channel Search]
(Cable only) and start tuning
Automatic Channel Search
Scan 0%
Scan Mode Advance
Frequency (kHz)
Modulation
Symbol Rate (ksym/s)
306000
Auto
Auto
Network ID 999
Scan

The function items vary depending on the country
you select. (p. 11)

[Scan Mode]
[Full]: Scans the whole frequency range. Settings
are made automatically. [Frequency] and [Network
ID] are not available.
[Quick]: Scans according to the settings you made
in [Network ID].
[Advance]: Scans according to the settings you
made in [Frequency] and [Network ID].

Normally set [Frequency] and [Network ID] to
[Auto].If [Auto] is not displayed or if necessary,
enter the value specified by your cable provider
with numeric buttons.

After settings, select [Scan].