Operating Instructions

Warnings and Precautions

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a ﬁ tted three pin mains plug for your safety and convenience. A 5 amp fuse is ﬁ tted

in this plug. If the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by

ASTA or BSI to BS1362.

Check for the ASTA mark

ASA

or the BSI mark on the body of the fuse.

If the ﬁ tted plug has a removable fuse cover you must ensure that it is reﬁ tted when the fuse is replaced. If you lose

the fuse cover the plug must not be used until a replacement cover is obtained. Replacement fuse covers can be

purchased through your local Panasonic dealer.

The plug ﬁ tted to this appliance incorporates a mains ﬁ lter circuit. If this is removed or

replaced with a non– ﬁ ltered plug this television will no longer meet the European standards

for Electromagnetic Compatibility (EMC). If the ﬁ tted plug is unsuitable for the socket outlet

in your home an appropriate adapter should be used.

Nonetheless, if the ﬁ tted plug is replaced, the fuse should be taken out and the cut- off plug

disposed of safely. There is danger of severe electrical shock if the cut off plug is inserted

into any 13 amp socket.

If a new plug is to be ﬁ tted please observe the wiring code as shown below.

If in any doubt please consult a qualiﬁ ed electrician.

How to replace the fuse (for plug type shown in example 1):

Lift out the removable fuse compartment with a screwdriver and replace the fuse, then reﬁ t securely into the mains

plug (see example 1).

How to replace the fuse (for plug type shown in example 2):

Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace the fuse, then press the fuse

cover down securely (see example 2).

Example 1

Example 2

IMPORTANT: – The wires in the mains lead of this appliance are coloured in accordance with the following code:–

BLUE : NEUTRAL BROWN : LIVE

As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your

plug, proceed as follows:–

1. The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.

2. The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.

IMPORTANT NOTE: Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug,

marked with the letter ‘E’ or the earth symbol

Fitting remote control batteries

• Make sure that the batteries are ﬁ tted the correct way round.

• Do not mix old batteries with new batteries. Remove old, exhausted batteries immediately.

• Do not mix different battery types, i.e. Alkaline and Manganese or use rechargeable (Ni-Cd, Ni-MH) batteries.

Pull and hold the hook, then

open the battery cover.

Insert batteries - note correct

polarity ( + and

“R6 (UM3)” size

Replace the cover.

321