Instruction Book

For an external recording device to record DVB programmes, the integrated DVB system must be active to provide

the signal. The Timer programming menu allows you to choose programmes that you wish to record. At the correct

time, the DVB system will switch on and tune to the correct station (even if the TV is in standby mode). If the

recording device is compatible with Q---Link or similar technologies (see page 39) and connected to the TV’s AV1 /

AV2 terminal, you do not need to program the device --- the DVB system will control the recording process.

ThedevicemustbeconnectedtotheTV’sAV1/AV2terminalusingaSCARTcabletorecordDVBprogrammes.

In DVB mode

Press the MENU button.

Move to Setup menu.

Access Setup menu.

Move to DVB Setup Menu.

Access DVB Setup Menu.

Move to Timer Programming.

Access Timer Programming.

Press the OK button to begin programming.

Select the Programme position to be recorded.

Move to the Date field.

Set the date on which the recording is to take place.

The current Date and Time are shown at the top of

themenu.Seepage32forfurtherDateoptions.

Move to the Start time field and set the Start time.

Move to the End time field and set the End time.

The duration of the recording is shown in the min. column.

The channel position, start and end times can also be

input using the numeric buttons on the remote control.

Move to the Subtitles field.

If you wish to record subtitles (if available) select Auto.

Press the OK button to store.

Press the EXIT button to leave

the DVB Timer Programming screen.

Notes:

STo delete a timer programme, select the recording with the cursor bar and press the Red button.

STo edit a previously entered timer programme, select it with the cursor bar and press the OK button.

STimer programmes can also be entered from the TV Guide.

Two minutes before the recording is due to start, a reminder will appear on screen: Press the OK button to remove

the reminder from the screen. If you wish to cancel the recording, press the EXIT button.

Notes: The above 2 operations will not be necessary if the TV set is in standby mode.

Six seconds before the recording is due to start the DVB system will tune to the correct station. If you were already watching another

DVB station you will see the station change on screen. If you were watching an analogue channel, you will not see the change.

You can continue to watch analogue stations while a timer recording is in progress. If you attempt to switch to another DVB

programme position while a timer recording is in progress the message “DVB Tuner Locked “will be displayed. Press the OK button

to continue recording, or EXIT to unlock the programme position. Beware that if you press EXIT, timer programming for this DVB

position will be immediately deleted. To immediately cancel a recording that is already in progress, press GUIDE then EXIT.

Timer programming menu (DVB mode)

EXIT