Operating Instructions

30
H Service
Before requesting service, please refer to the troubleshooting
guide on previous page to determine the symptoms. To obtain
service please contact your local Panaso nic dealer quoting the
model number and serial number (both are located at the rear of
the TV).
H TV Games / Home Computers
Extended use of TV games orhome computerswith any television
set can cause a permanent ‘shadow’ on the screen. This type of
irreversible picture tube damage, can be limited by observing the
following points:
D Reduce the brightness and contrast levels to a minimum
viewing level.
D Do not operate thetelevision s etfor a continuous period of
time while using TV games or home computers.
D This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.
H Last Position Memory
Certain functions have a last position memory, i.e. the setting at
thetimeofswitch-- off will be the setting used when the receiver is
switched on again:--
Programme Tint
OSD language (M.NTSC / NTSC only)
AV Position Contrast
Volume Sharpness
MPX Aspect
Bass Standby
Treble Artificial Intelligence (AI) --- Picture
Balance Colour
Colour Balance Brightness
Status Ambience
P-- NR Teletext mode
V olume correction Q-- Link
Decoder (AV2) Geomagnetic correction
Flicker reduction
H Sleep Feature
If the set is not switched o ffwhen theTV stationstops transmitting ,
it will automatically go to standby mode after 30 minutes. This
function will not operate when the TV is in AV mode.
TX--32PL10P/M TX--28PL10P
Power Source 220 -- 240V 50Hz A.C.
Power Consumption 120W 124W
Standby Consumption
1,4W 1,4W
Picture Tube
Visible Diagonal
76 cm 66 cm
Audio Output
Music Power
2 x 7W RMS (2 x 15W MPO), 8Ω impedance
Dimensions
H
W
D
547 mm
845 mm
550 mm
508,8 mm
763,2 mm
512,2 mm
Weight 56 kg 42 kg
Receiving
S
y
s
t
e
m
s
/
PALB/G,H,SECAMB/G
VHF E2 -- E12 VHF H1 -- H2 (ITALY)
VHF A -- H(ITALY) UHFE21-- E69
CATV (S01 -- S05) CATV S1 -- S10 (M1 -- M10)
CATV S11 -- S20 (U1 -- U10) CATV S21 -- S41 (Hyperband)
P
A
L
D
/
K
S
E
C
A
M
D
/
K
Systems/
Band name
P
A
L
D
/
K
,
S
E
C
A
M
D
/
K
VHF R1 -- R2 VHF R3 -- R5
VHF R6 -- R12 UHF E21 -- E69
PAL 525/60 Playback of NTSC tape from some PAL video recorders (VCR)
M.NTSC (AV input only) Playback from NTSC 4,43 MHz Videorecorders (VCR)
NTSC (AV input only) Playback from NTSC Videorecorders (VCR)
Number of programme
positions
99 + VCR
Aerial -- Rear UHF / VHF
Headphones -- Front 3,5mm, 8Ω impedance
AV -- Rear
AV1 -- 21 pin terminal -- Audio/Videoin/out,RGBin.
AV2 -- 21 pin terminal -- Audio / Video in/out, S-- Video in, Q-- Link
2 x RCA Audio Monitor Out.
AV -- Front AV3 -- S---Video in, 2 x RCA Audio in, 1 x RCA Video in.
Specifications are subject to change without notice. Weight and dimensions shown are approximate.
FORYOURGUIDANCE
SPECIFICATIONS