Operating Instructions - Language - English

22
MENU
Commom Interface
IDTV
OK
123
456
789
C
0
N
MODE
EXIT
OK
DVB Timer programming
DVB Tuner lock
DVB System Setup
AV2 out
Setup menu
Access
Off
AV2
Q-Link
Off
Shipping condition
Off
New Service Message
Monitor
TV
DVB Auto Setup
Child lock
Power on preference
Off timer
Off
Signal Quality
Common Interface Module
Preferred Subtitles
Settings
DVB System Setup
English
Screensaver Active
Default
Access
Display Timeout
3 seconds
After 2 minutes
System Update
Favourites Setup
Main menu
Picture menu
Setup menu
Sound menu
Slot 1: No module inserted
Common Interface
Access
Switch on the TV.
During DVB mode
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose DVB System Setup.
Access DVB System Setup.
Move to choose Common Interface Module.
Access Common Interface Module.
Access the module.
Common Interface Module menu
The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
These can be inserted in the “CI” slot located at the rear of the TV.
IMPORTANT NOTES:
• Switch off the TV using the front panel switch before inserting or removing a module.
•
If you are installing a TV software update, please follow the dedicated instructions supplied with the module.
• Insert / remove a module straightly to the CI slot.
Insert the CI module:
Some Common Interface Modules may be a two piece design consisting
of a card reader together with the viewing card. When using this design
of card, first insert the card reader firmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
If no module is inserted the message “No Module Inserted” will be
displayed.
(If you have inserted a module, check that it is fully inserted.)
The features that now appear on screen are dependent on the contents
of the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
In all cases, it is possible to navigate the pages using buttons on the
remote control, but because the commands available must apply to all
manufacturers of DVB equipment, some on screen commands may not
correspond exactly to the remote control buttons.
For example:
For the on screen command ‘select’ or ‘go’, use the OK button.
If you see the symbols, use the cursor keys.
If you see a line of key words displayed in red, green, yellow
and blue, use the coloured buttons to operate the functions.
The EXIT button should always allow you to exit the CI
software.