Quick Start Guide

English
17
First time Auto Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.

These steps are not necessary if the setup has been
completed by your local dealer.

Please complete connections (p. 11 - 14) and settings
(if necessary) of the connected equipment before
starting Auto Setup. For information about the settings
for the connected equipment, read the manual of the
equipment.
1 
and turn the power on

Takes a few seconds to be displayed.
2 Select the following items
Set up each item by following the on-screen instructions.
Example:

Home Shop
 How to use the remote control
Move the cursor
Access the item / store the setting
Return to the previous item (if available)
Select the language
Select [Home]
Select [Home] for use in a home viewing environment.

[Shop] is for shop display.

To change the viewing environment later on, the set
will need to have all settings initialised by accessing
Shipping Condition.



Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).

[Start Auto Setup]
: tune (search for the available channels)
: skip tuning

Auto Setup screen varies depending on the country
and the signal mode you select.

[DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Auto Setup is now complete and the

If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
Note

The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
Menu is set to [On].

The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu
is set to [On].

To retune all channels
[Auto Setup] in [Tuning Menu] (Setup Menu)

To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] (Setup Menu)

To initialise all settings

Menu)