Operating Instructions

English
38
Note

Non-playable files are also listed but cannot be
selected.

You can use the following buttons during playback.
Confirm the remote control code is “73”.
(p. 30)
 Playback of sharing content on this TV with
the DMC (Digital Media Controller) network
equipment
You can enjoy content stored in the media server by
controlling with the DMC network equipment connected
to your home network.

For details, refer to [eHELP] (Search by Purpose >
Network).
 Sharing the content of this TV with another
piece of network equipment
You can enjoy the content of this TV with another
network equipment connected to your home network.

For details, refer to [eHELP] (Search by Purpose >
Network).
FAQs
Before requesting service or assistance, please follow
these simple guides to solve the problem.

For details, refer to [eHELP] (Support > FAQs).
The TV does not switch on

Check the mains lead is plugged into the TV and the
mains socket.
The TV goes into Standby mode

Auto power standby function is activated.
The remote control does not work or is intermittent

Are the batteries installed correctly?
(p. 18)

Has the TV been switched on?

The batteries may be running low. Replace them with
new ones.

Point the remote control directly at the TV’s remote
control signal receiver (within about 7 m and a
30
degree angle of the signal receiver).

Situate the TV away from sunshine or other sources
of bright light so they do not shine on the TV’s remote
control signal receiver.

Is the remote control mode wrong?
(p. 18)
No image is displayed

Check the TV is turned on.

Check the mains lead is plugged into the TV and the
mains socket.

Check the correct input mode is selected.

Check the setting of [AV] ([COMPONENT] / [VIDEO])
in [Input Selection] to match the signal being output
by the external equipment.

Is [Backlight], [Contrast], [Brightness] or [Colour] in
the Picture Menu set to the minimum?

Check all required cables and connections are firmly
in place.
An unusual image is displayed

This TV has a built-in Self Test. Makes a diagnosis of
picture or sound problems.
[TV Self Test] (Help Menu)

Turn the TV off with Mains power On / Off switch,
then turn it on again.

If the problem persists, initialise all settings.
[Shipping Condition] in [System Menu] (Setup
Menu)