Operating Instructions
Table Of Contents
- Read first
- Home
- Watching
- Recording
- Media Player
- Network
- Internet content
- Home network
- Network connections
- Network settings
- Network Connection
- Custom - Wireless
- Custom - Wired
- Custom - Wireless Access Point
- Network Status
- TV Name
- TV Remote App Settings
- Network Link Settings
- Smart Speaker Settings
- TV>IP Server Settings
- Mirroring Settings
- Control4 Settings
- VOD Content Refresh
- Software Update
- New Software Message
- IPv6
- Terms of Service and Settings
- Samba Interactive TV Settings
- Photos
- Videos
- Music
- Supported format
- Functions
- Settings
- Support
Note
●
Dual tuner function (watching or recording 2 programmes simultaneously,
watching a programme while recording another programme, etc.) is not
available while using TV>IP server function.
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming, the TV must be either on or in
Standby.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
Depending on the network condition, recording function may not work
properly in TV>IP.
●
When the start time comes, the channel may be switched automatically
and the video and audio signals may be output. 2 minutes before the start
time, a reminder message may appear if you are watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
●
LED lights orange in Standby mode when Timer Programming is set.
●
“!” identifies that three or more timer events are overlapped. As for
the overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
●
The recording of Timer Programming may automatically change the
channel to the programmed channel a few seconds before the start time.
●
For details of the USB HDD
Recording > Technical information
- 157 -