Operating Instruction

English - 27 -
will be displayed, press OK button to complete software
upgrade process and restart TV.
3 AM search and upgrade mode
Your TV will search for new upgrades at 3:00 o’clock
if Automatic scanning option is set to Enabled and
if the TV is connected to an aerial signal or to the
Internet. If a new software is found and downloaded
successfully, it will be installed at the next power on.
Note: Do not unplug the power cord while led is blinking during
the reboot process. If the TV fails to come on after the upgrade,
unplug, wait for two minutes then plug it back in.
All updates are automatically controlled. If a manual search
is carried out and no software is found then this is the current
version.
Troubleshooting & Tips
TV will not turn on
Make sure the power cord is plugged in securely to a
wall outlet. Press the Standby button on the remote.
Poor picture
 Check if you have correctly tuned the TV.
 Low signal level can cause picture distortion. Please
check antenna connections.
 Check if you have entered the correct channel
frequency if you have performed manual tuning.
No picture
 TV is not receiving any signal. Make sure the correct
source has been selected.
 Is the antenna connected properly?
 Is the antenna cable damaged?
 Are suitable plugs used to connect the antenna?
 If the content is received through an HDMI input, try
changing the related HDMI source input setting to
Enhanced or Regular from the Source Settings
option in the Sources menu or the Sources option
in the Settings>System menu.
 If you are in doubt, consult your dealer.
No sound
 Check if the TV sound is muted. Press the Mute
button or increase the volume to check.
 Sound is coming from only one speaker. Check the
balance settings from the Sound menu.
 Check if the Sound Output option is set correctly
from the Sound menu.
 If the content is received through an HDMI input, try
changing the related HDMI source input setting to
Enhanced or Regular from the Source Settings
option in the Sources menu or the Sources option
in the Settings>System menu.
Remote control - no operation
 The batteries may be exhausted. Replace the
batteries.
 The batteries maybe inserted incorrectly. Refer to
the section “Inserting the Batteries into the Remote”.
No signal on an input source
 It is possible that no device is connected.
 Check the AV cables and connections from your
device.
 Check the device is switched on.
HDMI Signal Compatibility
Source
Supported Signals
Available
HDMI
480i 60Hz O
480p 60Hz O
576i, 576p 50Hz O
720p 50Hz,60Hz O
1080i 50Hz,60Hz O
1080p
24Hz,
25Hz,
30Hz,
50Hz,
60Hz
O
3840x2160p
24Hz,
25Hz,
30Hz,
50Hz,
60Hz
O
4096x2160p
24Hz,
25Hz,
30Hz,
50Hz,
60Hz
O
(X: Not Available, O: Available)
In some cases a signal on the TV may not be displayed
properly. The problem may be an inconsistency with
standards from the source equipment (DVD, Set-top
box, etc. ). If you do experience such a problem please
contact your dealer and also the manufacturer of the
source equipment.