Quick Start Guide
23
English
Set up the network connection
≥ Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
≥ Auto Setup screen varies depending on the country
and the signal mode you select.
≥ [DVB-S Antenna Setup]
Ensure the satellite connections are completed (p. 15)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
≥ [DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥ The TV goes into Standby mode when no operation is
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
≥ To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
≥ To add the available TV signal mode later
[Set up TV Signals] ([Setup] menu)
≥ To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)
Watching TV
1 Turn power on
or
2 Select the mode
≥ Selectable modes vary depending on the channels
stored.
3 Select a channel
or
≥ To select a channel position with 2 or more-digit, e.g.
399
Auto Setup is now complete and the TV
is ready for viewing.
Note
(TV)
(Remote Control)
≥ Mains power On / Off switch should be on.
(p. 22)
up
down
TX-43_49_55LX970E_TQB4GA0120_eng.book 23 ページ 2022年1月7日 金曜日 午後1時18分