Operating Instructions
Table Of Contents
- Read first
- Home
- Watching
- Recording
- Media Player
- Network
- Internet content
- Home network
- Network connections
- Network settings
- Network Connection
- Custom - Wireless
- Custom - Wired
- Custom - Wireless Access Point
- Network Status
- TV Name
- TV Remote App Settings
- Network Link Settings
- Smart Speaker Settings
- DVB-via-IP Server Settings
- Mirroring Settings
- Control4 Settings
- VOD Content Refresh
- Software Update
- New Software Message
- IPv6
- Terms of Service and Settings
- Samba Interactive TV Settings
- Photos
- Videos
- Music
- Supported format
- Functions
- Settings
- Support
Timer Programming
This function allows you to select programmes that you want to record to the
USB HDD.
1. Display TV Guide with GUIDE.
2. Select the forthcoming programme and press OK to access.
●
You can also set a timer event pressing .
●
To check / change / cancel a timer event
Recording > Timer Programming > Editing Timer Programming
●
LED lights orange in Standby mode when Timer Programming is set.
●
To return to TV Guide
BACK
●
If you select the current programme, a confirmation screen asking
whether you want to watch or record the programme appears. Select
Timer Programming and press OK to set USB HDD Rec. to record from
the time you finish the timer event setting.
●
is displayed on the TV Guide screen when Timer Programming is
set.
●
Depending on the country you select, you can set Signal Supported
Recording (see below).
= Note =
●
Not valid in Analogue
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
When recording programmes to the USB HDD, be sure to format the USB
HDD and enable it to record in USB Device Setup.
Recording > USB HDD setup
- 125 -