Operating Instructions
English
20
If tuning has failed check the RF cable, and the network
connection, and then follow the on-screen instructions.
Note
The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
Menu is set to [On].
The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu
is set to [On].
To retune all channels
[Auto Setup] in [Tuning Menu] (Setup Menu)
To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] (Setup Menu)
To initialise all settings
[Shipping Condition] in [System Menu] (Setup
Menu)
Watching TV
1 Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
(p. 19)
2 Select the mode
Selectable modes vary depending on the channels
stored.
3 Select a channel
up
down
or
DVB channel position begins from number 1 upward.
Analogue channel position numbers are in the 0 - 99
range.