DVB-S_Installation_Guide_for_HX700

English - 9 -

2.3. Antenna Type - Unicable

• Set the antenna type/satellite type to Singlecable or Jess Singlecable for Unicable satellite system.

Press OK, Singlecable and Jess Singlecable options will be available. Highlight the option that corresponds

to your system and press OK. (Singlecable = Unicable 1, Jess Singlecable = Unicable 2)

Highlight Tuner and press OK. Highlight the number of the user band which is allocated to your TV and press

OK.

The Band frequency option will change in accordance with the Tuner(User Band) selection. If you need to

change the frequency highlight Band frequency and press OK. Highlight the frequency of the user band

which is allocated to your TV and press OK. If you need to dene a di󰀨erent frequency highlight User dened

option and press OK.

User dened option can be used if you set the Band frequency option accordingly. Highlight User dened

and press OK. Enter the frequency using numeric buttons on the remote or use the virtual keyboard, then

highlight the tick mark on the keyboard and press OK.

Press the Right directional button to proceed.

• The position of the rst satellite option will appear as A and the status of it as On. If you need to change the

position, highlight that satellite option and press OK. Highlight Position and press OK. Position options will

be displayed. Highlight the option to which your satellite is allocated and press OK. (A=1, B=2, ...)

If you are going to perform a network scan (Scan Mode=Network) make sure that you also set the transponder

parameters of the network in this step. Highlight Transponder and press OK. Set to Frequency, Symbol

rate and Polarisation parameters according to the network. If you are going to perform a full scan (Scan

Mode=Full) you won’t need to set the transponder parameters.

If you have multiple satellites connected to your system, set an option for each satellite in your system. You

will need to set the Satellite Status option to On rst. Then you will be able to set other parameters of the

satellite. Set as mentioned above.

Press the Right directional button to proceed.