DVB-S_Installation_Guide_for_HX700

English - 6 -

2. General Satellite

2.1. Antenna Type - Direct

• Set the antenna type/satellite type to Universal for Direct satellite system. Press OK, highlight Universal

and press OK again.

Press the Right directional button to proceed.

• The status of the rst satellite option will appear as On.

If you are going to perform a network scan (Scan Mode=Network) make sure that you set the transponder

parameters of the network in this step.

Highlight the satellite, the status of which appears as On, and press OK.

Highlight Transponder and press OK.

Set to Frequency, Symbol rate and Polarisation parameters according to the network. If you are going to

perform a full scan (Scan Mode=Full) no actions are required here.

Press the Right directional button to proceed.

• Highlight Scan and press OK or Right directional button to proceed.