Operating Instructions

LED does not turn to red in Standby mode
●
LED turns to orange in Standby mode in the following conditions:
– Recording is in progress.
– Timer Programming is set.
– Home Network Server is set to On.
– Powered On by Apps is set to On.
– Home Streaming is set to Always.
– Powered On by Easy Mirroring is set to On.
– VOD Content Refresh is set to On and VOD content is updated.
– TV Anywhere is set to On.
– DVB-via-IP Server Settings is set to Enable DVB-via-IP server.
●
LED turns to orange during adjustment of the panel (approx. 10 minutes to
maximum 80 minutes). LED turns to orange again in standby mode when
the TV is turned on / off before the panel adjustment is completed. (Be
sure to turn the TV off with the remote control to adjust the panel.)
The panel maintenance notification is displayed when turning the TV off with
Standby On / Off switch of the TV’s remote control.
●
Perform the panel maintenance. Select Turn the TV off now and press OK
to start the panel maintenance.
– The panel maintenance is interrupted when selecting Don’t start panel
maintenance this time or turning the TV off while the notification is
displayed.
When pushed with a finger, the display panel moves slightly and makes a
noise
●
There is a little gap around the panel to prevent damage to the panel. This
is not a malfunction.
- 355 -