Operating Instructions

English
20
 Remote Control Mode Reset
You can make a forced reset of the TV’s remote control
mode to change to mode 1.
1 Get another Panasonic remote control whose remote
control mode has been set to 1
2 Point the remote control at the TV, then press the
MUTE button for about 15 seconds
3 When a screen asking you to confirm the forced reset
of the remote control mode is displayed, press the
MUTE button again for about 3 seconds
Indicator / Control panel

When pressing 4, 5, 6 buttons, the control panel
guide appears on the right side of the screen for
3 seconds to highlight which button has been
pressed.
1 2,3
5
6
7
4
Rear side of the TV
Note

Location of indicators may vary depending on the
models.
1 Power LED
Red:
Standby
Green:
On

Depending on the ambient brightness,
adjusts the brightness of LED to easy-to-view
levels automatically.
Orange:
Standby with some functions (recording, etc.)
active

The LED blinks when the TV receives a command
from the remote control.
2 Ambient sensor

Senses brightness to adjust picture quality when
[Ambient Sensor] in the Picture Menu is set to
[On].
3 Remote control signal receiver

Do not place any objects between the TV remote
control signal receiver and remote control.
4 Input mode selection

Press repeatedly until you reach the desired mode.
[Main Menu]

Press and hold for about 3 seconds to display main
menu.
OK (when in the menu system)
5 Channel Up / Down

Cursor Up / Down (when in the menu system)
6 Volume Up / Down

Cursor Left / Right (when in the menu system)
7 Mains power On / Off switch

Use to switch the mains power.

To turn Off the apparatus completely, you must pull
the mains plug out of the mains socket.

[
]: Standby / On