Quick Start Guide

25
English
≥ When pressing 4, 5, 6 buttons, the control panel guide
appears on the right side of the screen for 3 seconds
to highlight which button has been pressed.
1 Remote control signal receiver (for infrared
communication)
≥ Do not place any objects between the TV remote
control signal receiver and remote control.
2 Ambient sensor
≥ Senses ambient lighting conditions to adjust the
picture when [Auto Brightness] and [Auto White
Balance] (Picture > Ambient Sensor Settings) are
set to [On].
3Power LED
Red:
Standby
Green:
On
• Depending on the ambient brightness, adjusts
the brightness of LED to easy-to-view levels
automatically.
Orange:
Standby with some functions (recording, etc.)
active or panel maintenance in progress
≥ The LED blinks when an infrared signal is received
from the remote control.
4 Input mode selection
≥ Press repeatedly until you reach the desired mode.
Menu
≥ Press and hold for about 3 seconds to display the
menu bar.
OK (when in the menu system)
5 Channel Up / Down
≥ Cursor Up / Down (when in the menu system)
6 Volume Up / Down
≥ Cursor Left / Right (when in the menu system)
7 Mains power On / Off switch
≥ Use to switch the mains power.
≥ To turn Off the apparatus completely, you must pull
the mains plug out of the mains socket.
≥ [ ]: Standby / On
Be sure to turn the TV off with the remote control to
perform the panel maintenance. The panel maintenance
automatically starts, and it takes approx. 10 minutes.
During the panel maintenance, LED turns to orange.
≥ During panel maintenance, avoid touching and
exerting any pressure on the screen. (e.g. wiping the
screen, etc.)
≥ For information about panel maintenance, refer to
[eHELP] (Search by Purpose > Watching > For best
picture > Screen Settings).
Indicator / Control panel
123
5
6
7
4
Rear side of the TV
Panel maintenance
TX-42_48_55_65LZW804_TQB4GA0205-1_eng.book 25 ページ ２０２２年４月２７日 水曜日 午前１１時３３分