Quick Start Guide

26
English
First time Auto
Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.
≥ These steps are not necessary if the setup has been
completed by your local dealer.
≥ Please complete connections (p. 14 - 18) and settings
(if necessary) of the connected equipment before
starting Auto Setup. For information about the settings
for the connected equipment, read the manual of the
equipment.
1 Plug the TV into a live mains socket
and turn the power on
2 Select the following items
Set up each item by following the on-screen instructions.
Example:
∫ How to use the remote control
Select the language
Select your country
Select [Home]
Select [Home] for use in a home viewing environment.
≥ [Shop] is for shop display.
≥ To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection
≥ Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
≥ Auto Setup screen varies depending on the country
and the signal mode you select.
≥ [DVB-S Antenna Setup]
Ensure the satellite connections are completed (p. 15)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
≥ [DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥ The TV goes into Standby mode when no operation is
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
≥ To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
≥ To add the available TV signal mode later
[Set up TV Signals] ([Setup] menu)
≥ To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)
≥ Takes a few seconds to be displayed.
Move the cursor
Access the item / store the setting
Return to the previous item (if available)
Please select your viewing environment.
ShopHome
Auto Setup is now complete and the TV
is ready for viewing.
Note
TX-42_48_55_65LZW804_TQB4GA0205-1_eng.book 26 ページ ２０２２年４月２７日 水曜日 午前１１時３３分