Operating Instructions

English
21
Set up the network connection

Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]

Auto Setup screen varies depending on the country
and the signal mode you select.

[DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Auto Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
Note

The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
Menu is set to [On].

The TV goes into Standby mode when no signal
is received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu
is set to [On].

To retune all channels
[Auto Setup] in [Tuning Menu] (Setup Menu)

To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] (Setup Menu)

To initialise all settings
[Shipping Condition] in [System Menu] (Setup
Menu)
Watching TV
1 Turn power on
(TV)
or
(Remote Control)

Mains power On / Off switch should be on.
(p. 20)
2 Select the mode
TV Selection
DVB-S
DVB-C
DVB-T
DVB-via-IP
Analogue

Selectable modes vary depending on the channels
stored.
3 Select a channel
up
down
or

To select a channel position with 2 or more-digit, e.g.
399