Operating Instructions

- 73 -
Postcode:
Sets your postcode to receive local information in the GUIDE Plus+
system (only available in some countries).
System Information:
Displays the system information of the GUIDE Plus+ system (only
available in some countries).
●
DVB-T and Analogue channels are displayed on the same TV Guide
screen. D and A may be displayed to distinguish DVB-T and Analogue
channels. There will be no programme listings for Analogue channels.
Timer Programming
This function allows you to select programmes that you want to be reminded
to watch or record to the USB HDD.
1. Select the forthcoming programme with
/ / / and press OK to
access.
2. Select USB HDD Rec. / Reminder with
/ and press OK to set.
●
To check / change / cancel a timer event
Recording > Timer Programming > Editing Timer Programming
●
LED will turn to orange in Standby mode if Timer Programming is set.
●
To return to TV Guide
BACK/RETURN
●
If you select the current programme, a confirmation screen asking
whether you want to watch or record the programme appears. Select
Timer Programming with / and press OK to set USB HDD Rec. to
record from the time you finish the timer event setting.
●
is displayed on the TV Guide screen if Timer Programming is set
from TV Guide.
●
Depending on the country you select, you can set Signal Supported
Recording (see below).
= Note =
●
Not valid in Analogue
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
When recording programmes to the USB HDD, be sure to format the USB
HDD and enable it to record in USB Device Setup.
Recording > USB HDD setup