Operating Instructions

English

Set up the network connection

Select your region

Auto Setup is now complete and the

TV is ready for viewing.

If tuning has failed check the RF cable, and the network

connection, and then follow the on-screen instructions.

Note



The TV goes into Standby mode when no operation

is performed for 4 hours if [Auto Standby] in the Timer

menu is set to [On] (factory setting).



The TV goes into Standby mode when no signal is

received and no operation is performed for

10 minutes if [No signal Power off] in the Timer menu

is set to [On] (factory setting).



To retune all channels

[Auto Setup] in [Tuning Menu] ([Setup] menu)



To add the available TV signal mode later

[Add TV Signal] in [Tuning Menu] ([Setup]

menu)



To initialise all settings

[Shipping Condition] in [System Menu] ([Setup]

menu)

Watching TV

1 Turn power on

(TV)

(Remote Control)



Mains power On / Off switch should be on.

(p. 22)

2 Select the mode

TV Selection

Freeview



Selectable modes vary depending on the stored

channels and selected country.

3 Select a channel

down



DVB channel position begin from number 1 upward.

Analogue channel position numbers are in the 0 - 99

range.