Quick Start Guide

English
22
First time Auto Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.

These steps are not necessary if the setup has been
completed by your local dealer.

Please complete connections (p. 13 - 16) and
settings (if necessary) of the connected equipment
before starting Auto Setup. For information about
the settings for the connected equipment, read the
manual of the equipment.
1 Plug the TV into a live mains socket
and turn the power on

Takes a few seconds to be displayed.
2 Select the following items
Set up each item by following the on-screen instructions.
Example:
Please select your viewing environment.
Home Shop
 How to use the remote control
Move the cursor
Access the item / store the setting
Return to the previous item (if available)
Select the language
Select your country
Select [Home]
Select [Home] for use in a home viewing environment.

[Shop] is for shop display.

To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection

Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]

Auto Setup screen varies depending on the country
and the signal mode you select.

[DVB-S Antenna Setup]
Ensure the satellite connections are completed
(p. 15) and select the tuner mode ([Dual Tuner] /
[Single Tuner]).

[DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Auto Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the
on-screen instructions.
Note

The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).

The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer menu
is set to [On] (factory setting).

To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)

To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)

To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)