Quick Start Guide

English
24
FAQs
Before requesting service or assistance, please follow
these simple guides to solve the problem.

For details, refer to [eHELP] (Support > FAQs).
The TV does not switch on

Check the mains lead is plugged into the TV and the
mains socket.
The TV goes into Standby mode

Auto power standby function is activated.
The remote control does not work or is intermittent

Are the batteries installed correctly?
(p. 19)

Has the TV been switched on?

The batteries may be running low. Replace them with
new ones.

Point the remote control directly at the TV’s remote
control signal receiver (within about 7 m and a
30 degree angle of the signal receiver).
*

Situate the TV away from sunshine or other sources
of bright light so they do not shine on the TV’s remote
control signal receiver.
*

Is the remote control mode wrong?
(p. 20)

If you are trying to use voice controls, is the remote
control registered (paired) with the TV? (p. 17)
When infrared communication is used
No image is displayed

Check the TV is turned on.

Check the mains lead is plugged into the TV and the
mains socket.

Check the correct input mode is selected.

Is [Backlight], [Contrast], [Brightness] or [Colour] in
the Picture menu set to the minimum?

Check all required cables and connections are firmly
in place.
An unusual image is displayed

This TV has a built-in Self Test. Makes a diagnosis of
picture or sound problems.
[TV Self Test] ([Help] menu)

Turn the TV off with Mains power On / Off switch,
then turn it on again.

If the problem persists, initialise all settings.
[Shipping Condition] in [System Menu] ([Setup]
menu)
The image or sound from external equipment are
unusual when the equipment is connected via HDMI

Set [HDMI Auto Setting] ([Setup] menu) to [Mode1].
(p. 15)
No sound is produced from the connected HDMI
equipment

Set the audio output format of the connected HDMI
equipment to PCM.
Voice control function does not work

If the remote control is not registered (paired) with the
TV, register (pair) the remote control.
(p. 17)

Check the network connections and settings.
Parts of the TV become hot

Parts of the TV may become hot. These temperature
rises do not pose any problems in terms of
performance or quality.
When pushed with a finger, the display panel moves
slightly and makes a noise

There is a little gap around the panel to prevent
damage to the panel. This is not a malfunction.
About the inquiry

Please contact your local Panasonic dealer for
assistance.
If you make an inquiry from a place where this TV
is not present, we cannot answer about contents
that require visual confirmation for connection,
phenomenon, etc. of this TV itself.