Operating Instructions

- 48 -
■ DVB-C
1. Enter the frequency with numeric buttons
●
Normally set Symbol Rate and Service ID to Auto.
2. Select Start scan with
/ and press OK to search
■ DVB-T
1. Select a channel with / and adjust frequency with / for each
channel
●
Set where the level of Signal Quality becomes the maximum.
2. Press OK to search
■ Analogue
Set Analogue channel manually after Auto Setup.
●
Set Sound System and Colour System, and then perform this function.
Normally set Colour System to Auto.
– SC1: PAL B, G, H / SECAM B, G
– SC2: PAL I
– SC3: PAL D, K / SECAM D, K
– F: SECAM L, L’
1. Select the channel position with numeric buttons
2. Select the channel with Channel Up / Down button
3. Search with /
4. Select Store with / and press OK to set
●
Use Fine Tuning to make small adjustments to the tuning of an individual
programme (affected by weather conditions, etc.).
●
If a VCR is connected only with the RF cable, select channel position 0.
Update Channel List
By updating the DVB channel list, you can add new channels, delete removed