Operating Instructions

Tuning and Editing Channels ●
(DVB)
Advanced
41
Display a notification message
New Channel Message
Selects whether to give a notification message when a new DVB channel is found. (Off / On)
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Selecting OK will perform “Update Channel List”.●
Check DVB signal
Signal Condition
Selects a channel and checks the DVB signal condition.
To change the channel
●
A good Signal Strength is not an indication of suitable
signal for DVB reception. Please use the Signal Quality
indicator as follows:
Signal Quality:
Green bar ● Good
Yellow bar ● Poor
Red bar ● Bad (Check the Terrestrial aerial, cable or
Satellite dish)
DVB-S:
DVB-S Signal Condition
Channel Name 1 BBC 1 East (W)
Signal Quality
Signal Strength
Satellite
010
010
Astra 19.2° E
Bit Error Rate 0.00E+00
Parameter 10847MHz, H, 22000kS/s
DVB-C:
DVB-C Signal Condition
Channel Name 70 CBBC Channel
Signal Quality
Signal Strength
Network Name
010
010
Wenvoe
Bit Error Rate 0.00E+00
Parameter 802,00 MHz, 64 QAM, 6940 kS/s
DVB-T:
DVB-T Signal Condition
Channel Name 70 CBBC Channel
Signal Quality
Signal Strength
Network Name
010
010
Wenvoe
Bit Error Rate 0.00E+00
Parameter [CH62] 802,00 MHz
Reduce the DVB-C signal
Attenuator
If the DVB-C signal is too strong, the interference may occur. In this case set to “On” to reduce the signal
automatically.
This function is available only for DVB-C signal.●