Operating Instructions
Frequently Asked Questions ●
FAQs, etc.
93
Problem Actions
Network
Cannot connect to the network
Check the LAN cable or Wireless LAN Adaptor is connected ●
properly. (p. 67)
Check the connections and settings. (p. 67 - 71)
●
Check the network equipment and network environment.●
The router may not be set to issue IP address automatically. If the ●
network administrator prefers to allocate an IP address, set an IP
address manually. (p. 69)
The router may be using MAC address filtering (security setting).
●
Confirm the MAC Address of this TV (p. 68) and set the router to be
able to use it.
If the problem persists, consult your Internet Service Provider or
●
telecommunications company.
Cannot select the file during
DLNA operations
Is media server of the connected equipment prepared? (p. 66)●
Check applicable data format. (p. 66)●
Cannot operate VIERA CAST
Check the connections and settings. (p. 67 - 71)●
The server or connected line might be busy now.●
Other
The TV does not switch On
Check the mains lead is plugged into the socket outlet.●
The TV goes into
“Standby mode”
Off Timer function is activated.●
The TV enters “Standby mode” about 30 mins. after analogue ●
broadcasting ends.
The remote control does not work
or is intermittent
Are the batteries installed correctly? (p. 8)●
Has the TV been switched On?●
The batteries may be running low. Replace them.●
Point the remote control directly at the front of the TV (within about ●
7 m and a 30 degree angle of the front of the TV).
Situate the TV away from sunshine or other sources of bright light
●
not to shine on the TV’s remote control signal receiver.
Parts of the TV become hot
Even when the temperature of parts of the front, top and rear ●
panels has risen, these temperature rises will not pose any
problems in terms of performance or quality.
The LCD panel moves slightly
when it is pushed with a finger
Clattered sound might be heard
There is some flexibility around the panel to prevent damage to the ●
panel.
The panel might move slightly when it is pushed with a finger, and
●
clattered sound might be heard. This is not a malfunction.
Overcurrent error message
appears
The connected USB device might cause this error. Remove the ●
device and turn the TV Off with Mains power On / Off switch, then
turn it On again.
Check if foreign objects are inside the USB port.
●
An error message appears
Follow the message’s instructions.●
If the problem persists, contact your local Panasonic dealer or the ●
authorized Service Centre.