Operating Instructions

Tuning and Editing Channels
50
Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
●
All channels found will be added to the Channel List.
DVB-C:
1 Enter the frequency 2 Select [Start scan]
74,00 MHz4
100%
100%
DVB-C Manual Tuning
Frequency
Auto Symbol Rate
Service ID
Auto
Start scan
Signal Quality
Signal Strength
No.
Channel Name Type New
select
access
●
Normally set [Symbol Rate] and [Service ID] to [Auto].
DVB-T
:
1 Adjust frequency for each channel 2 Search
100
[CH21]
474,00 MHz
%
100%
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
No. Channel Name Type New
select channel
adjust frequency
●
Set where the level of [Signal Quality] becomes the maximum.
Set Analogue channel manually [Manual Tuning]
[Fine Tuning]:
Use to make small adjustments to the tuning of an individual programme (affected by weather conditions, etc.).
[Manual Tuning]:
Set Analogue channel manually after Auto Setup.
●
Set [Sound System] and [Colour System], and then perform this function. Normally set [Colour System] to [Auto].
●
If a VCR is connected only with the RF cable, select channel position [0].
SC1
CH331 BBC1
278 411
Analogue Manual Tuning
Fine Tuning
Manual Tuning
Sound System
Colour System
Store
Auto
SC1: PAL B, G, H / SECAM B, G
SC2: PAL I
SC3: PAL D, K / SECAM D, K
F: SECAM L, L’
1 Select the channel position 2 Select the channel
3 Search 4 Select [Store]
select
store