Operating Instructions
- 201 -
Service Replacement
(On / Off)
Set to On to display a message to switch to the available service (only
available in some countries).
●
For DVB-C mode
Signal Condition
Checks the signal condition.
Watching Tuning and editing channels Signal Condition
●
Not valid in Analogue mode
Antenna System
(One LNB / MiniDiSEqC / DiSEqC 1.0 / Single Cable)
Sets the antenna system to use plural LNBs for receiving several satellites.
Watching Tuning and editing channels Auto Setup
●
This TV supports DiSEqC Version 1.0.
●
For DVB-S mode
LNB Configuration
Selects the satellite for each LNB.
Watching Tuning and editing channels Auto Setup
●
For DVB-S mode
Attenuator
(On / Off)
Automatically reduces the DVB-C signal to avoid the interference.
●
If the DVB-C signal is too strong, the interference may occur. In this case,
set to On to weaken the signal automatically.
Add TV Signal
Adds the TV mode.
●
This function is available if you skip any modes to tune in Auto Setup for
first using the TV.