Operating Instructions

5
 Assembling the pedestal
B
2
3
1
A
C
D
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
1 Remove the assembly screws
from the TV.
2 Pull out the pedestal from the TV.
3 Remove the assembly screws from the bracket.
Secure the base as shown below to prevent the TV
from falling over.

The place where the base is secured should be thick
enough and made of hard material.
Commercially available screw
(not supplied)
Diameter: 3 mm
Length: 25 - 30 mm
Connections

External equipment and cables shown are not supplied with this TV.

Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.

Check the type of terminals and cable plugs are correct when connecting.

Always use a fully wired SCART or HDMI cable.

Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.

Also read the manual of the equipment being connected.
Terminals
7
8
4
6
5
2
1
3
1
CI slot (p. 7)
2
Headphone jack (p. 7)
3
USB port
4
HDMI1 - 2 (p. 6, 7)
5
Terrestrial / cable terminal
(p. 6)
6
AV1 (SCART) (p. 6)
7
AV2 (COMPONENT / VIDEO)
(p. 7)
8
DIGITAL AUDIO